OPERATING PRINCIPLE:
Through its effective and constant action, the MG2 collects all the impurities present in the system, preventing them from circulating within it, thus avoiding wear and damage of the rest of the components making up the system, circulators and heat exchangers in particular. MG2 performs a continuous protective action on the boiler.
USE:
It is advised to install MG2 on the return circuit, at the inlet of the boiler, in order to protect it from any impurities in the system, especially during the start-up phase. Thanks to its compact dimensions, MG2 it can be installed under the boiler, in systems for domestic use, where installation spaces are very limited and there is no room for a traditional dirt separator.
1
The sudden cross-section variation slows down the fluid motion and the entrainment rate of the particles suspended in it
2
The magnet, placed inside a cylinder at the centre of the filtration chamber, attracts all the impurities having magnetic characteristics
3
All magnetic and non-magnetic contaminants in the system are retained in the filtration chamber.
TRIPLE FILTRATION
- Swivel connection: It enables to easily connect the filter to connection G 3/4” M of the boiler
- Threaded connections G 3/4”: The design choice to make all the threaded connections of the main body of the same dimensions,allows for extreme installation versatility
- Shut-off system: During maintenance, it allows to isolate the filter from the delivery and return circuit
- Stainless steel fi ltering mesh
- Magnet protection conduit, removable
- Closure double filter cap
- Tightening ring nut
- Seal O-ring
- Safety drain plug: By removing it, it is possible to drain the fluid from the main body of the fi lter and to perform programmed cleaning operations, after intercepting the filter.
EXTREME INSTALLATION VERSATILITY
VERTICAL INSTALLATION
